Vnxe Root Access Free Space Pass

Pass Blades: Checking domain controller connectivity and configuration.

Working in the EMC Unified Storage Remote Support Lab, I see at least 10 new requests each day for a health check on an array and most of the time, there is nothing wrong.

Today Im going to show you some easy ways to see if there really is a problem or not.

While the VNX array is sold as Block, File, or Unified (a combination of both) the health checks are different for the Block side and the File side.

The first method I will demonstrate is the traditional way and is executed via the command line.

This method has been in place since the older celerra models and works the same way on them as well.

To kick off your health check, simply login to the control station using an SSH client and run the command nascheckup.

This process will take several minutes, so go get yourself a coffee and wait until you see something like the output below.

Pass Control Station: Checking if file system usage is under limit.

Pass Control Station: Checking if NAS Storage API is installed correctly.

Pass Control Station: Checking if NAS Storage APIs match NA Control Station: Checking if NBS clients are started.

Pass Control Station: Checking if NBS devices are accessible.

Pass Control Station: Checking if NBS service is started Pass Control Station: Checking if PXE service is stopped Pass Control Station: Checking if standby is up NA Control Station: Checking integrity of NASDB.

Pass Control Station: Checking all callhome files delivered Pass Control Station: Checking resolv conf.

Pass Control Station: Checking nas site eventlog configuration Pass Control Station: Checking nas sys mcd configuration Pass Control Station: Checking nas sys eventlog configuration.

Pass Control Station: Checking root disk reserved region Pass Control Station: Checking if RDF configuration is valid.

NA Control Station: Checking if fstab contains duplicate entries.

Pass Control Station: Checking if sufficient swap memory available.

Pass Control Station: Checking for invalid entries in etc hosts.

Pass Control Station: Checking for correct filesystem mount options.

Pass Control Station: Checking the hard drive in the control station Pass Control Station: Checking if Symapi data is present Pass Control Station: Checking if Symapi is synced with Storage System.

Pass Blades: Checking boot files Pass Blades: Checking if primary is active.

Vnxe Root Access Free Space Pass

Pass Blades: Checking if root filesystem is too large Pass Blades: Checking if root filesystem has enough free space Pass Blades: Checking network connectivity.